Hunt Auto Magnetos - Four Cylinder - External Coil - Page 1

$3.70 Cap Safety Pin

This safety pin prevents the cap screw from rotating loose.

Compare
$4.90 Cap Holding Screw

This is an original equipment replacement for Scintilla/Vertex type magneto cap screws. Includes nylon retaining ring.

Compare
$24.50 Rotor For Exernal Coil Magneto

This is the correct replacement Bakelite rotor for Joe Hunt standard external coil, H-2 and H-3 magnetos. It will also fit on Vertex magnetos with blue Standard brand rotors. Rotors must be checked periodically because play...

Compare
$85.65 Fixed Point

This is the fixed point used on all Vertex and Scintilla type magnetos. The body is nickel coated for corrosion resistance and the point itself is platinum to provide maximum current transfer and long life...

Compare
$88.70 Contact Point

This is the contact point used on all Vertex and Scintilla type magnetos. The body is nickel coated for corrosion resistance and the point itself is platinum to provide maximum current transfer and long life. Includes one...

Compare
$6.20 Ground Strap

Replace your worn or missing Ground Strap with this factory unit. This strap is often twisted or broken, which may lead to the magneto grounding itself out, or not being able to turn off after starting.

Compare
$9.85 Cam Wiper

Replace your worn or missing cam wiper to ensure that you get the maximum life out of your points. The wiper lubes the breaker cam over time so that the phenolic rubbing block on the points doesn’t wear...

Compare
$40.00 "Big Yellow" Condenser

Replace your damaged or worn out condenser. This unit was installed as original equipment in our H-3 Magnetos and is also used on Mallory magnetos that have been upgraded to produce higher than stock amperage. The rating on...

Compare
$38.65 High Output Condenser

This is the condenser that we use on our high output applications such as our H-2 and H-3 magnetos. It is also used on all Mallory magnetos that have a condenser on the inside of the housing. This condenser is rated at 0...

Compare
$69.95 Choose Options Auto Point Plate With Bearing

Replace your worn or missing Point Plate with this new factory unit. Over time the stud that the points pivot on can become loose which will not allow the points to be gapped accurately on all cylinders. Features a...

Compare
$39.65 Point Plate Replacement Bearing

Replace your worn of missing Point Plate Bearing with this new factory unit. An old bearing will allow the breaker cam to move side to side, which will not allow the points to be gapped accurately on all cylinders. Unit is a...

Compare
$10.95 Ground Terminal Assembly

This is a complete ground terminal assembly that will replace your damaged or missing assembly. Includes all of the hardware shown in the photo.

Compare
$6.90 Ground Terminal

This is the ground terminal that is located on the side of all internal coil magnetos. It is often bent or stripped, which could lead to the ground nut coming loose...

Compare
$7.85 Bakelite Ground Nut

This is the often missing Bakelite ground nut that screws onto the ground terminal located on the side of internal coil magnetos. It is used to retain wires attached to the ground terminal such as a kill switch or tach...

Compare
$255.00 Choose Options Rare Earth Magnet Assembly

Never have to worry about your magneto losing its charge again and increase your amperage at the same time with our rare earth magnet assembly. These come complete and ready to run with a heavy duty neodymium...

Compare
$79.85 Advance Kit

This advance kit will add 20 degrees of advance at the crankshaft to your magneto to aid in starting. Note: Advance installation instructions can be found under the instructions tab at the top of the Joe Hunt Magnetos...

Compare

Categories

Our Newsletter

External Coil